| # any empty lines and lines starting with '#' symbol are ignored |
| # |
| # The file should contain exactly two sections: router and link, each starting with the corresponding keyword |
| # |
| # router section defines topology nodes and their relative positions (e.g., to use in visualizer) |
| router |
| |
| # each line in this section represents one router and should have the following data |
| # node comment yPos xPos |
| |
| router0 NA 0 1 |
| router1 NA 1 1 |
| router2 NA 1 2 |
| router3 NA 1 3 |
| router4 NA 1 4 |
| router5 NA 1 4 |
| router6 NA 1 4 |
| router7 NA 1 4 |
| producer NA 2 1 |
| |
| |
| # Note that `node` can be any string. It is possible to access to the node by name using Names::Find, see examples. |
| |
| # link section defines point-to-point links between nodes and characteristics of these links |
| link |
| |
| # Each line should be in the following format (only first two are required, the rest can be omitted) |
| # srcNode dstNode bandwidth metric delay queue |
| # bandwidth: link bandwidth |
| # metric: routing metric // Set real routing metrics inside simulation file! |
| # delay: link delay |
| # queue: MaxPackets for transmission queue on the link (both directions) |
| |
| router0 router1 100Mbps 1 5ms |
| router0 router3 100Mbps 2 5ms |
| |
| router1 router2 100Mbps 3 5ms |
| router1 router4 100Mbps 4 5ms |
| |
| router2 router5 100Mbps 5 5ms |
| |
| router3 router4 100Mbps 16 5ms |
| router3 router6 100Mbps 1 5ms |
| |
| router4 router5 100Mbps 8 5ms |
| router4 router7 100Mbps 4 5ms |
| |
| router6 router7 100Mbps 5 5ms |
| |
| router5 producer 10Mbps 10 5ms |
| router7 producer 10Mbps 2 5ms |